Matrox

G200/G400/G450/G550 series

Matrox cards only work with /dev/i2c-* devices. To use them, you must load both matroxfb and i2c-matroxfb modules by typing, as root:

# modprobe matroxfb
# modprobe i2c-matroxfb

The kernel configuration options needed to enable Matrox framebuffer driver and I2C support are, at least:

  • Devices driversGraphics supportFramebuffer supportMatrox acceleration.
  • Devices driversGraphics supportFramebuffer supportMatrox accelerationG100/G200/G400/G450/G550 support.
  • Devices driversGraphics supportFramebuffer supportMatrox accelerationMatrox I2C support.

Matrox cards support table

These Matrox cards have been reported to work. If yours is not listed, please send a message to one of the DDCcontrol mailing lists (see Appendix A, Report problems and successes).

Name Works
dev PCI
Matrox G200 AGP No No
Matrox G450 AGP Yes No

SourceForge.net Logo